The SDR, ( Software Defined Radio ) RX Antenna Switch has been designed to allow an SDR or additional Receiver to be used in conjunction with a HF Radio Transceiver on a single Antenna. The switch provides >70dB isolation protection to the SDR RX when RF is applied from a 100 Watt HF Transceiver. In receive mode, a two way RF splitter is used to split the incoming Antenna signals between the SDR RX, and HF Transceiver. The switch is ideal if you want to use a SDR Play or similar SDR receiver for a spectrum scope on the same Antenna as a HF Transceiver. The switch has a hard wired PTT input that suits most Transceivers, and also an RF detector circuit for further protection in case the hard wired PTT is not connected. When the switch is powered off, the SDR RX connection is terminated into 50ohms, and the Antenna is connected to the HF Transceiver through the Relays.  The RF power handling is limited by the RF Detector that is rated to a maximum of 100 watts CW.

For more information see the EME222 Application Block Diagram

Please select the connector types that you require for the SDR RX, ANTENNA, and RADIO TRX connections.  Sorry UHF 259 types are not available.

The Product image shows a fully constructed Kit product.  Please refer to the Options Tab for the descriptions of the various products available.

Please Note: Built products usually need to be constructed and can take up to 2 weeks to ship depending on work load, but are normally shipped in few days.

EME222-KIT is the complete Kit that includes the PC board, instructions, all on board components, enclosure, hardware.  Requires complete construction, and soldering of some SMD components.

EME222-B Is a fully constructed and tested Product

Connector Option SDR RX is the RF connector that connects to a SDR Receiver. This option must be selected and is not optional.

Connector Option ANTENNA is the RF connector that goes to the main HF Antenna that is used for Transmitting. This option must be selected and is not optional.

Connector Option RADIO TRX  is the RF connector that goes to the Radio Transceiver.  This option must be selected and is not optional.

The  connectors must be selected when ordering either the Kit or built product, and are available in BNC and N, types.

All Kits are built Products include a 2.1mm DC power cable

Specifications
Frequency Range:
500kHz to 150MHz
RX Insertion Loss:
<3.7dB from 1 to 150MHz
TX Insertion Loss:
<0.15dB from 1 to 150MHz
Return Loss:
>25dB from 1 to 150MHz
Relay Isolation from Radio to RX Active:
>70dB from 0.5 to 150MHz
RF Power Handling:
100 Watts CW maximum 1.8 to 150MHz
Operating Voltage: +13.8vdc @ 35mA nominal ( +15vdc maximum )
Product Size: 110mm L x 60mm W x 46mm H ( Includes Connectors )

For more information see the EME222 KIT WEBPAGE

Please refer to the EME222 Application Block Diagram on how this Kit is used

SDR Receiver Antenna Switch

  • Brand: Mini-Kits
  • Product Code: EME222-KIT
  • Quantity In stock: 10
  • $79.95


Available Options


Related Products

UA01 UHF-Male to BNC-Female
BNA02 BNC-Male to UHF-Female
13 Pin DIN Male Plug Connector
RCA Audio Cables
RG58C/U BNC Male to BNC Male Coaxial Cable Assy 50cm
RG58C/U BNC Male to BNC Male Coaxial Cable Assy 100cm