Direct Digital Synthesizer Experimenters Kit using an Analogue Devices 14 bit 400MHz AD9954 DDS chip, which is suitable as an accurate signal generator, or as a VFO for a RX or TX project. A bi-directional translator chip is used to interface the DDS chip with the IDC header connector for 5v logic. The various connections on the header allows the board to be used with many micro controller projects found on the WEB, including the Mini-Kits M1-DDS Controller Kit using the M1-DDS software. The DDS output uses a 175MHz 7th order elliptic L.P.F. and GALI-84 amplifier for clean +10dBm output. For low noise, the PC Board uses plated through holes and separate analogue and digital ground planes, and power supplies.
The Product image shows a fully constructed Kit product. Please refer to the Options Tab for the descriptions of the various products available.
Please Note: Built products usually need to be constructed and can take up to 2 weeks to ship depending on work load, but are normally shipped in few days.
Basic Kits are only suitable for those that want to use their own Micro-controller and hardware. For a complete Micro-controller solution to use with this DDS board, please see the complete M1-DDS Controller Kit
For the highest performance and reliability, this Kit uses a Genuine Analogue Devices AD9954YSVZ chip and high quality on board components direct from suppliers in the USA.
EME165 KIT2 is the Basic Kit that includes the PC board, Instructions, all on board components, and a female SMA. Requires complete construction and soldering of SMD components.
EME165 KIT2S is the Basic EME165 KIT1 but has the AD9954 DDS chip pre-soldered to the board. Requires complete construction and soldering of SMD components.
EME165 KIT2B is a fully constructed and tested product with female SMA.
EME165 PCB Only includes the PC board and Kit construction notes. No on board components are included.
Kits and built products Do Not include miscellaneous hardware, or enclosures. Please Note: That no micro-controller or Software support is included with these products.
The AD9951/54 DDS is Highly recommended for high performance receivers due to the low spur level of the 14 bit D-A
|Frequency Range: ||DC to 175MHz ( AD9954 ) |
|RF Output: ||+10dBm ( 10mW ) +/- 0.5dB|
|RF Bandwidth: ||0.1 to 100MHz @ 1dB, 156MHz -3dB |
|Low Pass Filter: ||175MHz 7th order elliptic |
|Spurious Output: ||100MHz clock -45dBm, 2nd harmonic -36dBc, 3rd -54dBc, all other > -50dBc |
|Board Interface: ||+5v logic levels on inputs and outputs common pins, +3v on other connections |
|Clock:||100MHz and uses the x4 multiplier inside the AD995x for a 400Mhz clock|
|Operating Voltage:||+5vdc @ 120mA, +12vdc @ 100mA|
|Board Size:||65mm L x 50mm W x 15mm H|
Basic AD9954 DDS VFO
- Brand: Mini-Kits
- Product Code: EME165 KIT2
- Quantity In stock: Discontinued Product