The EME215 Active receive antenna switch is ideal for use with the Mini-Kits Active whip and loop antenna amplifiers when used with a HF Transceiver that only has a single antenna socket.  This then allows automatic switching from the receive only to the main antenna when going from RX to TX mode.  The Active RX only antenna can also be switched out manually to the main antenna if required using the power on/off toggle switch.   The design incorporates a bias tee to power the RX Active amplifier via the coaxial cable, and includes protection for the RX Active by using a high isolation Relay that deactivates if no power is present.  In case the PTT connection has been disconnected but the RX Active switch is powered up, then a  further safeguard protection using a RF detector automatically switches the relay from RX to TX mode deactivating the relay protecting the RX Active.    The board is fitted with PTC protection to safeguard against any short circuits on the RX Active connection, and uses a Transorb for over voltage and reverse polarity protection. EME215 Application Block Diagram

Please select the connector types that you require for the RX Active, Radio, and Antenna connections.  

The Product image shows a fully constructed Kit product.  Please refer to the Options Tab for the descriptions of the various products available.

Please Note: Built products usually need to be constructed and can take up to 2 weeks to ship depending on work load, but are normally shipped in few days.