This Product Has Been Discontinued

DC to 70MHz Direct Digital Synthesizer Kit using an Analogue Devices 10 bit 180MHz AD9851 DDS chip, which is suitable as an accurate sinewave signal generator, or as a VFO for a Receiver or Transceiver project. The various connections on the IDC header allows the board to be used with many micro controller projects found on the WEB, including the EME170 PIC Controller, or M1-DDS Controller Kits.   The DDS output uses a 70MHz 5th order elliptic low pass filter, and high IP3 Gali amplifier for a clean +10dBm output.

The Product image shows a fully constructed Kit product.  Please refer to the Options Tab for the descriptions of the various products available.

Please Note: No software or Micro controller Hardware etc is included with the Basic DDS Kits. The Mini-Kits DDS Controller Kits and software are recommended for this Kit.

For more detailed information on how this module Kit can be used, Please refer to the EME167 KIT webpage.

Please Note: Built products usually need to be constructed and can take up to 2 weeks to ship depending on work load, but are normally shipped in few days.

EME167 KIT1 is the Basic Kit that includes the PC board, Instructions, all on board components, and SMA female. Requires complete construction and soldering of SMD components.

EME167 KIT1S is the Basic EME167 KIT1 but has the AD9851 DDS chip pre-soldered to the board.  Requires complete construction and soldering of SMD components.

EME167 KITB1 is a fully constructed and tested product with a SMA female.

EME167 KIT1 PCB Only includes the PC board and Kit construction notes. No on board components are included.

Kits and built products Do Not include miscellaneous hardware, or enclosures.  Please Note: That no micro-controller or Software support is included with these products.

Frequency Range:
DC to 70MHz ( AD9851 )
RF Output:
+10dBm ( 10mW ) +/-0.5dB from 1 to 40MHz, -3dB @ 70MHz
Low Pass Filter:
70MHz 5th order elliptic
Spurious Output:
30MHz clock -55dBc, 2nd harmonic -32dBc, 3rd -50dBc
Board Interface:
+5vdc logic levels on input and outputs.
Clock: 30MHz and uses the AD9851 internal x6 multiplier
Operating Voltage: +12 to 14vdc ( +12vdc @ 130mA )
Board Size: 65.5mm L x 45mm W x 15mm H

For more information see theEME167 KIT WEBPAGE

Please refer to the DDS-VFO Block Diagram on how this Kit is used

Basic AD9851 DDS VFO

  • Brand: Mini-Kits
  • Product Code: EME167 KIT1
  • Quantity In stock: Discontinued Product
  • $83.95

Available Options

Related Products

M1-DDS Controller Kit
AD9851 I/Q DDS