|
|
|
|
 |
NEW
COMPONENTS IN STOCK
We
stock a good range of quality electronic components &
hardware to suit many construction projects. Let Mini-Kits supply components for your next project, including standard leaded & SMD resistors & capacitors.
SURPLUS
STOCK
|
 |
 |
|
|
|
|
 |
NEW! The
EME181 Series RX Bias Tee Kits are designed to power many receive only preamplifier kits
including the EME173 & 179 Series Kits via a coaxial cable. The Kits are easy to construct & are available for the 6m ( 50MHz ), to the 23cm ( 1.2GHz ) Bands. The Bias Tee can supply up to 25 volts DC at 160mA.
KITS ARE IN STOCK
Mini-Kits
Imports products regularly from suppliers worldwide
& can supply many products not normally
stocked. |
 |
 |
|
|
|
|
|
 |
The largest range of RF connectors & adaptors In Stock.
Types include SMA, N, BNC, UHF, F, TNC, Cables include RG178,
179, ,316, LMR195, LMR240, LMR400. We also have crimp tools & dies to suit.
Hundreds of other connectors are available by Special Order.
If it's on this website then it's in stock. |
 |
 |
|
| MITSUBISHI AMPLIFIER KITS |
|
|
 |
|
Mini-Kits Stock a number of Amplifier Kits from 50MHz to 1.2GHz that use Mitsubishi modules. All Kits suitable for linear & non linear modes, including SSB & FM Television.
KITS ARE IN STOCK
All our Kits are available as a built PC boards, or complete products in boxes.
|
 |
 |
|
| RX ONLY PREAMPLIFIER KITS |
|
|
 |
Basic
receive only Preamp Kits are available for
6M, 2M, 70cm, & 23cm
Our very popular RX Preamplifiers
have been designed to be easy to construct &
can be used for various applications including
weak signal SSB, FM, ATV, & 137MHz Weather
Satellite reception.
All Preamplifier Kits are now available as built products with SMA connectors, or complete in boxes.
IN STOCK
|
 |
 |
|
|
|
|
 |
NEW! Mini-Kits stock a range of simple broadband amplifier Kits that use the Mini-Circuits Gali & PHA-1 devices. These amplifier Kits can be used as a
gain block for a Radio design, or as a simple wide band preamplifier
in the front of a scanning receiver, or TV set.
Kit notes have just been updated with designs to construct either a wideband masthead preamplifier, or reference locking the Icom IC910,
IN STOCK
|
 |
 |
|
| MICROWAVE MULTIPLIER KITS |
|
|
 |
|
Mini-Kits stock a range of local oscillator Multiplier Kits to suit the 3.4 to to 10GHz Amateur
Bands. These are easy to construct & tune & have guaranteed performance.
These Kits are suitable for multiplying lower frequency local oscillator signals, & 1200MHz FM ATV transmitters to use on the higher Microwave bands.
IN STOCK
|
 |
 |
|
|
|
|
 |
The Mini-Kits 23cm, ( 1200MHz ) preamplifier Kit is the best product available. The High performance of this product is guaranteed requiring no tuning to easily achieve a noise figure under 0.4dB & over 34dB gain.
This Preamplifier can easily be re-tuned for Seti use at 1420MHz.
A complete boxed product with sma is now available
KITS ARE IN STOCK
|
 |
 |
|
|
|
|
 |
This Direct
Digital Synthesizer Experimenters Kit is also available built, & uses the uses the Analogue Devices 14 bit 400MHz AD9954 DDS
chip. The Kit is is suitable as an accurate signal generator, or
as a VFO for a RX or TX project.
The AD9954 DDS Kit is a part of a complete HF-DDS Kit set that can be used to construct high performance Receivers or Transceivers.
IN STOCK |
 |
 |
|
|
|
 |
The Mini-Kits EME157 Masthead preamplifier Kits are available for both the 6 & 2M Bands.
This is one of our most popular Kits which is available as either a Kit, or fully built & tested in a waterproof masthead box.
IN STOCK
|
 |
 |
|
|
|
|
 |
There are two power head Kits available that can be used to measure RF up to 7GHz. Both can be used either simply with a multimeter, or with our DDS VFO KIt running the SWEEP KIT software.
IN STOCK |
 |
 |
|
|